-40%
C2 Redline 6 Gauge Set, Silver Bezels, 73-10 Ohm Fuel Level, Electric Speedo
$ 289.87
- Description
- Size Guide
Description
Comp II LED Redline 6-Gauge SetBlack Dials with Red Accents, Silver Anodized Aluminum Bezel, Glass Lens, White Through Dial Lighting
Why Buy From Us?
We double check each gauge for correct operation before packing your order. This process includes putting signals to all gauges to verify correct operation.
We verify no accessory items are missing (u-clamps, bulbs, senders etc) .
We photo document your order to ensure completeness.
Fast shipping via USPS Priority Mail service.
"No hassle" extended warranty. If you buy from us and have an issue with a gauge just send it back and we'll replace it, even it is more than 1 year later.
Features:
High quality gauges made in Orange County, CA USA.
High-speed full sweep stepper motor speedometer and tachometer
Speedometer in Miles per Hour and KM per Hour
Short sweep electric 2-1/16" gauges
Programmable speedo with one-step easy calibration and 2 Trip meters
Fuel level gauge available in 5 different ranges (*see below for more info)
White through-the-dial LED lighting with stylish red accents for easy viewing at night
3D glowing pointer for easy visibility at night
Why pay 0+ for a comparable set?
Set includes:
3-3/8" Electric Programmable Speedometer, 0-160 MPH (0-240 KM per Hour)
3-3/8" Tachometer, 0-10,000 RPM
2-1/16" Volts, 8-18V
2-1/16" Oil Pressure, 0-100 PSI with sender
2-1/16" Water Temperature, 120-280F with sender
2-1/16" Fuel Level Empty-Full, 73-10 Ohm input range.
Through-Dial LED Lighting
This set features through-the-dial LED lighting and glowing 3D pointer for a cool look and easy viewing at night.
Made in the U.S.A.
This item is made in California, USA. Please allow 1-2 days for your item to be made before it ships.
Matching Vac/Boost, Trans Temp, Oil Temp & Fuel Pressure Gauges
Matching Vac/Boost, Transmission Temperature, Oil Temperature, and Fuel Pressure gauges are available for this gauge set. Please contact us to order.
Frequently Asked Questions
Are sending units included?
The oil pressure and water temp sending units are included.
The volts gauge does not require a sender.
A fuel level sender is not included. The fuel level gauge is a 73-10 ohm fuel level gauge. We can also supply the following fuel level gauge ranges as special order:
0-90 ohm (GM)
20-150 ohm (Most FORD vehicles after 1985)
0-30 ohm (Most GM Vehicles Before 1965)
240-33 ohm
If you need a range other than 73-10 ohm DO NOT purchase this set. Let us know what fuel level range you need and we will add an eBay listing for a set with the fuel level range you need.
Speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions:
Pulse range generated proportional to the vehicle speed
Signal with minimum 3V peak to peak signal - typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs
output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm)
If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender. If you need a hall effect sender we can add a FORD or GM/Mopar hall effect sender to your order for a nominal charge. Contact us for details. The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) drives the electric speedometer.
The tachometer does not require a sender - you get the signal from the coil (-) or other tach signal source (i.e. ECU or Tach output on HEI or ignition box).
TERMS & CONDITIONS
Standard terms and conditions apply to this item. See our terms and conditions here:
Terms & Conditions
.
Rev: 11/5/17